Related Searches: Tungsten Carbide Mould Series | Tungsten Carbide Moulding | Tungsten Carbide Moulding Series | Tungsten Carbide Cold Heading Mould
Product List

Tungsten Carbide Mould Series

Tungsten Carbide Mould Series

1. Tungsten Carbide Die for Tooling

Description
Tungsten carbide extruding dies are manufactured with the highest quality carbide. Featuring high compressive strength, this kind of tungsten carbide die can handle extreme pressure and can provide higher quality finished products. Our company can customize to your specifications. We provide both solid tungsten carbide dies and tungsten carbide inserted dies in a steel casing body. These dies can provide you with the same set-up of your present steel application, but give you the performance and quality of a carbide die.
Application
Tungsten carbide stamping dies can be manufactured in various sizes and configurations based on customers' drawings. We can provide both solid tungsten carbide stamping dies and tungsten carbide inserted dies in a steel casing body.
Tungsten carbide shaving dies are used to remove surface defects that occur in the drawing process. These are available in various sizes and configurations.

2. Tungsten Carbide Wire Drawing Die

Description
For steel wire and other large-size wire drawing applications, tungsten carbide die is ideal that makes cost savings a priority over die wear resistance and wire surface finish. Its hole sizes normally vary from 0.15 mm to 50 mm. Tungsten carbide die we manufacture characterizes excellent corrosive wear resistance and available sizes.
Application
Tungsten carbide wire drawing die is a wise economical choice for most ferrous wires, large diameters and applications where corrosive wear is the primary cause of die failure. This tungsten carbide die can be used for carbon steel wire of all sizes, tire cord and welding wire.

Properties and Applications of Tungsten Carbide Die


Grade Density
g/cm³
T.R.S
MPa
Hardness
HRA
Performance & application recommended Approx
Grades in
China
MK11 14.4 2420 88.5 Forming or stamping dies for metal powders and nonmetal powders. YG11
MK15 14.0 2500 87.5 For fabricating drawing dies of steel tubes and rods under high compressibility ratio; punching, stamping and forging tools under large stress. YG15
MG20 13.5 2800 85.5 For fabricating stamping dies, spring plates of musical instruments, battery jars, small sized steel balls, screws, screw caps. YG20
MK05 14.9 2500 90.5 Mostly used as the buttons of small and mediumsized percussion bits and as the inserts of rotary prospecting bits to cut soft and medium hard formations. YK05
MK8C 14.7 2400 88.5 YG8C
YM32 13.7 2800 84.5 Impact resistance forging dies. YG16C
YM36 13.7 2800 84.5 Impact resistance forging dies, hot-press forging dies and rollers. YG18C
YM40 13.5 2850 83.5 Dies for wear resistant or impact resistant application. YG20C
ZL40.2
YM45 13.3 2900 83.0 Nut forming dies and high impact resistance forging dies. YG22C
ZL40.5
YM50 13.1 2950 82.5 Stainless bolt header dies and rollers. YG25C
ZL40B
YM90A 13.2 3200 82.0 Screw cap forming dies with high impact resistance (Highest impact resistance forging dies).

Package and Transformation

We pack tungsten carbide dies in plywood case and send them by ocean or air.
Related Products